how to factory reset wisenet dvr without password

How to Factory Reset Wisenet DVR without Password

If you’ve forgotten the password for your Wisenet DVR and urgently need to perform a factory reset, there are a few steps you can follow to accomplish this. Please note that this process will erase all settings and configurations on the DVR, and you will need to set it up again from scratch.

Step 1: Power off the DVR

Make sure the DVR is turned off properly. If it is currently on, locate the power cable at the back of the device and unplug it from the power source. It is crucial to ensure that the DVR is not receiving any power during the reset process.

Step 2: Locate the reset button

On the front or back panel of the DVR, you should find a small reset button. This button is usually recessed and will require a pointed object like a pen or paper clip to press it. Look for a small hole labeled “RESET” or a button with an icon resembling a circular arrow.

Step 3: Press and hold the reset button

Using your chosen pointed object, gently press and hold the reset button for approximately 15-20 seconds. It’s important to hold down the button consistently for the duration mentioned to ensure a successful reset process.

Step 4: Power on the DVR

While still holding the reset button, plug the power cable back into the DVR. Continue holding the reset button for about 10 more seconds, and then release it.

Step 5: Complete the factory reset

After releasing the reset button, wait for the DVR to finish booting up. This may take a few minutes. The DVR will now be restored to its default factory settings, including the password. You can log in using the default username and password combination, which is often “admin” for both fields.

It is highly recommended to change the default password after successfully logging in to ensure the security of your Wisenet DVR. Additionally, make sure to write down your new password in a safe place to avoid any future password-related issues.


Performing a factory reset on your Wisenet DVR without the password is possible by following the steps outlined above. Remember, a factory reset erases all settings and configurations, so be prepared to set up your DVR again once the process is complete. Always take note of your new password and keep it in a secure location to prevent any inconvenience in the future.

Leave a Comment